Natural Stone Anchoring Systems
Natural stone anchoring systems enable a safe and easy installation of the natural stone slabs by dowelling them or mortaring them in the anchoring ground.
Three-dimensionally adjustable anchors, which are attached to load-bearing walls with either anchor bolts or mortar, are part of the most common method for stone fastening systems in the construction industry.
The HAZ system solutions are suitable for all types of rear structures, regardless of whether they are concrete walls, blockwork, masonry or steel structures.
There are different types of natural stone anchors in different sizes, which fit the specification of the respective cavity walls, support the corresponding stone load or can withstand the wind loads.
Careful analysis of the stone construction must be performed to select the most efficient fastening solution.
The following points must be considered when designing a natural stone fastening system:
- Type and size of natural stones
- Overhang (= dimension from the front edge of the anchoring ground to the front edge of the facade panel)
- Anchoring in the vertical and horizontal anchoring joint
- joint width
- Concrete or masonry grade
- Building height, width and length
- wind zones
- Seismic loads
- valid plans, views and sections
The technical department of HAZ Metal will be pleased to advise you and to offer you technical solutions even for more complicated requirements
Undercut Anchors
- For attachments to natural stone walls
- Wet drilling system with matching drilling equipment is required
- Innovative attachment variant
- Detailed information can be obtained from our natural stone department
AXO Body Anchor
- To be fastened in the concrete with bolt anchors
- Projections up to 260 mm
- Recommended for vertical loads and wind loads up to 1300N
- Installation on horizontal and vertical joints.
- Optimal static performance
- Three-dimensionally adjustable
HZ Z Anchor
- To be fastened in the concrete with bolt anchors.
- Overhang up to 150 mm possible
- Vertical load up to 500N, wind loads up to 350N
- Mounting on horizontal or vertical joints
- Three-dimensionally adjustable
HA04-S L Anchor
- Direct mounting on concrete with bolt anchors possible
- Can be used for flagstones with thicknesses of more than 50 mm
- For vertical loads up to 800N, wind loads up to 655N
- Installation only in horizontal joints
HDM Mortar Anchor
- Direct mounting on concrete or brick wall with mortar
- Suitable types for loads in certain ranges and overhangs up to 240 mm available
- Recommended for loads up to 1200N
- Installation in horizontal or vertical joints.
- Three-dimensionally adjustable
Direct Attachment to Concrete Walls With Bolt Anchors
Direct Attachment to Concrete Walls or Masonry With Mortar
The attachment to load-bearing walls is often done with Bolzenankem.
The insulation is severed at each anchor point.
The insulation piece is brought back into position when the anchor has been fastened. Component joints are sealed with insulating tape to prevent thermal bridges.
The insulation is severed at each anchor point.
The insulation piece is brought back into position when the anchor has been fastened. Component joints are sealed with insulating tape to prevent thermal bridges.
The attachment to load-bearing walls is done with mortar anchors
The insulation is pierced at each anchor point.
Drilled holes are filled with mortar and anchors inserted into the mortar filled holes. The mortar should harden before starting work.
The insulation is pierced at each anchor point.
Drilled holes are filled with mortar and anchors inserted into the mortar filled holes. The mortar should harden before starting work.